Configuration Guide 39
Before You Begin
Network Information
You can configure your I/O switch modules using the CMC, as outlined in
"Configuring a Switch Module Network Ethernet Port Using the Web-Based
Interface
" on page 39
(the default IP address for the CMC is 192.168.0.120),
through the CMC CLI via serial console redirection, direct access to the I/O
module’s serial port (if supported), or using the I/O module’s default IP address
(if supported).
Switch Modules
Configuring a Switch Module Network Ethernet Port Using the
Web-Based Interface
You can use the CMC Web-based interface to configure an I/O module’s
Ethernet port.
NOTE: Use this procedure to configure the switch’s out-of-band Ethernet port. The
switch’s in-band management IP address is configured through the switch’s
external ports. These two IP addresses must be different, and on different
networks.
NOTE: To change settings on the I/O module configuration page, you must have
Fabric Administrator privileges for the particular Fabric in which the module is
installed.
NOTE: The network IP address set on the I/O module by the CMC is not saved to a
configuration file. To save the IP address configuration permanently, use the
connect switch-n RACADM command, or use a direct interface to the I/O
module GUI.
NOTE: Do not attempt to configure I/O module network settings for Ethernet
passthrough or Infiniband switches.
1
Log in to the CMC’s Web-based interface. See "Logging in to the CMC
Using the Web-Based Interface" on page 25.
2
Select
I/O Modules
in the
Chassis
menu in the system tree.
3
Select the
Setup
tab. The
Configuring
I/O Modules Network Settings
page appears.
R433Cbk0.book Page 39 Wednesday, July 30, 2008 6:05 PM
