Produtos da Marca Dell

Back to Contents Page



Adding and Removing Parts

Dell™OptiPlex™SX280User'sGuide



Before You Begin

This section provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the

following conditions exist:

l You have performed the steps in "Shutting Down Your Computer."

l You have read the safety information in the Product Information Guide that shipped with your computer.

Recommended Tools

The procedures in this document may require the following tools:

l Small flat-blade screwdriver

l Phillips screwdriver

l Flash BIOS update program floppy disk or CD

Shutting Down Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to ensure your own personal safety.



1. Shut down the computer.

2. Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut

down your computer, turn them off now.



3. Disconnect any telephone or telecommunication lines from the computer.

4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.

5. Remove the cable cover, if used.

6. Remove the computer cover.

Back to Contents Page

Before You Begin

Hard Drive

Removing the Computer Cover

Memory

Battery

Module Bay

Chassis Intrusion Switch

Processor

Chassis Speaker

Replacing the Computer Cover

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal

mountingbracket.Holdacomponentsuchasaprocessorbyitsedgesorbyitsmetalmountingbracket.Holdacomponentsuchasaprocessorby

its edges, not by its pins.

NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not

covered by your warranty.

NOTICE: When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable itself. Some cables have a connector with

locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep

them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and

aligned.

NOTICE: Toavoiddamagingthecomputer,performthefollowingstepsbeforeyoubeginworkinginsidethecomputer.

NOTICE: Todisconnectanetworkcable,firstunplugthecablefromyourcomputerandthenunplugitfromthenetworkwalljack.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the

computer.Whileyouwork,periodicallytouchanunpaintedmetalsurfacetodissipateanystaticelectricitythatcouldharminternalcomponents.