Client Systems Management Administrator’s Guide 11
10
Return to the previous menu to exit the MEBx Setup and save AMT configuration. The system will
display an Intel ME Configuration Complete message and restart. After the ME Configuration is
complete, you can configure AMT.
11
P
ress <Ctrl><P> during POST to enter MEBx Setup again.
12
Type the MEBx password.
13
Select
Intel AMT Configuration.
14
Select
Host Name
, and then type a host name.
NOTE: Spaces are not accepted in the host name. Make sure there is not a duplicate host name on the network.
You can use host names in place of the system’s IP for any applications requiring the IP address.
15
Select
TCP/IP.
a
When prompted to
Disable Network Interface,
select
N
. If the network is disabled, then all
remote AMT capabilities are disabled and TCP/IP settings are not necessary. If prompted to
enable
Enable Network Interface
, select
Y
.
b
In the
DHCP Disable
setting select
N
, or select
Y
if the setting is
DHCP Enable
.
c
Select
Domain Name,
and then type the domain name.
16
Select
Provisioning Server
.
a
Type the Provisioning Server IP. The default setting is 0.0.0.0. The default setting of 0.0.0.0 will
work only if the DNS server has an entry that will resolve the name
provisionserver
to the IP of the
provisioning server.
NOTE: DHCP and DNS must be available for the setup and configuration server search to automatically
succeed. If DHCP and DNS are not available, then the setup and configuration server’s IP address must be
manually entered into the AMT system’s MEBx.
b
Type the Port. The default setting is 0. If left at the default setting of 0, the AMT will attempt to
contact the provisioning server on port 9971. If your provisioning server is listening on a different
port, enter it here.
17
Select
Provision Model.
a
When prompted to
Change to Intel AMT 1.0 Mode,
select
N
to enable Intel AMT 2.0 Mode.
b
When prompted to Change to
Small Business,
select
N
to enable Enterprise mode. If prompted
to
Change to Enterprise
, select
Y instead.
c
Select
Return to previous menu
.
18
Select
Set PID
and
PPS
. This option is for Provisioning ID (PID) and Provisioning Passphrase (PPS)
entry. PIDs are 8 characters and PPS are 32 characters. There are dashes between every set of 4
characters, so including dashes, PIDs are 9 characters and PPS are 40 characters. An S&CS must
generate these entries.
19
Skip
Un-Provision
. This option returns the system to factory defaults. For more information on
unprovisioning, see "Return to Default" on page 17.
20
Select
VLAN
. The default setting for this option is
Disabled
.
