Specifies the primary IP port of the image server with which the client software communicates.
The default IP port is 06910.
Specifies how the client obtains the IP address.
l Static IP
l DHCP (default)
Specifies the static IP address of the client.
The default IP address is 255.255.255.255
NOTE: To set Client IP you must set Client DHCP to Static IP
Specifies the subnet mask for the client.
The default setting is 255.255.255.255
NOTE: To set the Client SubnetMask you must set Client DHCP to Static IP
Specifies the gateway IP address for the client.
The default setting is 255.255.255.255
NOTE: To set the Client SubnetMask you must set Client DHCP to Static IP
Displays the current license status.
When enabled (default), your computer starts more quickly because it skips certain configurations and tests.
Enables or disables the NumLock feature when your computer starts.
When enabled (default), this option activates the numeric and mathematical features shown at the top of each key. When disabled, this option
activates the cursor-control functions labeled on the bottom of each key
Allows you to specify the function keys to display on the screen when the computer starts.
l Enable F2 = Setup (enabled by default)
l Enable F12 = Boot menu (enabled by default)
Enables or disables keyboard error reporting when the computer starts.
This option is enabled by default.
sign-on displays a message stating the keystroke sequence required to enter the Manageability Engine BIOS Extensions(MEBx) Setup program.
This option is enabled by default.
Set the maximum memory for operating system to load while installation. If enabled the maximum available memory is 256 MB RAM.
This option is disable by default.
Reason being some operating system will not complete install with more then 2 GB of memory.
Displays the system event log and allows you to:
l Clear Log
l Mark all Entries
