Produtos da marca Dell

Changing Boot Sequence for Future Boots



1. Enter system setup utility (see Entering System Setup Utility).



2. Use the arrow keys to highlight the Boot menu option and press <Enter> to access the menu.



3. Press the up- and down-arrow keys to move through the list of devices.



4. Press plus (+) or minus (–) to change the boot priority of the device.

Clearing Forgotten Passwords and CMOS Settings



1. Follow the procedures in Before You Begin.



2. Remove the top cover (see Removing the Top Cover).



3. Remove the top bracket (see Removing the Top Bracket).



4. Remove the optical drive (see Removing the Optical Drive).



5. Remove the drive bay (see Removing the Drive Bay).



6. Locate the 3-pin CMOS connector on the system board (see System Board Components).



7. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.



8. Wait for approximately five seconds to clear the CMOS setting.



9. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.



Inspiron 300



NOTE: Write down your current boot sequence in case you want to restore it.

WARNING: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

WARNING: The computer must be disconnected from the electrical outlet to clear the CMOS setting.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

CAUTION: Clearing the CMOS settings will also clear the password.