Produtos da Marca Dell

Back to Contents Page

 Antenna-In Connector (Optional)

Dell™Inspiron™One2205ServiceManual

Removing the Antenna-In Connector

Replacing the Antenna-In Connector



Removing the Antenna-In Connector



1. Follow the instructions in Before You Begin.



2. Follow the instructions from step 2 to step 9 in Removing the System-Board Shield.



3. Remove the hex nut that secures the antenna-in connector to the system-board shield.



4. Release the antenna-in connector from the slot on the system-board shield.



5. Lift the antenna-in connector along with its cable away from the system-board shield.

Replacing the Antenna-In Connector



1. Follow the instructions in Before You Begin.



2. Slide the antenna-in connector into the slot on the system-board shield.



3. Replace the hex nut that secures the antenna-in connector to the system-board shield.



4. Follow the instructions from step 4 to step 11 in Replacing the System-Board Shield.



5. Connect your computer and all attached devices to electrical outlets, and turn them on.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

antenna-in connector

hex nut

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.