Produtos da Marca Dell

Back to Contents Page

 Display

Dell™Inspiron™One2205ServiceManual

Display Bezel

Display Panel

Display Cable



Display Bezel



Removing the Display Bezel



1. Follow the instructions in Before You Begin.



2. Remove the system board (see Removing the System Board).



3. Remove the 19 screws that secure the display bezel to the chassis.



4. Carefully peel the silver foil that adheres the camera module to the chassis from the chassis.



5. Make a note of the camera cable, infrared-card cable, and Bluetooth

-card cable routing and release the cables through the slots on the chassis.



6. Turn the computer over.



7. Release the three tabs that secure the display bezel to the chassis.



8. Using your fingertips, carefully pry up the inside edge of the display bezel.



9. Lift the display bezel away from the computer.



10. Remove the camera module (see Removing the Camera Module).



11. Remove the infrared card (see Removing the Infrared Card).



12. Remove the Bluetooth card (see Removing the Bluetooth Card).

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).