Produtos da Marca Dell

Back to Contents Page

 Front I/O Panel

Dell™Inspiron™535/537/545/546ServiceManual

Removing the Front I/O Panel

Replacing the Front I/O Panel

Removing the Front I/O Panel



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Remove the bezel (see Removing the Front Bezel).



4. Disconnect all the cables that are connected to the I/O panel from the system board connectors.



5. Remove the screw that secures the I/O panel to the chassis.



6. Carefully remove the I/O panel from the computer.

Replacing the Front I/O Panel



1. Align and slide the I/O panel clamp into the I/O panel clamp slot.



2. Replace the screw that secures the I/O panel to the chassis.



3. Connect the cables to the system board connectors.



4. Replace the bezel (see Replacing the Front Bezel).



WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)

removed.

NOTE: Note the routing of all cables as you remove them so that you can re-route them correctly when installing the new front I/O panel.

CAUTION: When sliding the I/O panel out of the computer, be extremely careful. Carelessness may result in damage to the cable connectors and

thecableroutingclips.

I/O panel clamp slot

cables

I/O panel clamp

I/O panel

screw



CAUTION: Take care not to damage the cable connectors and the cable routing clips when sliding the I/O panel into the I/O panel clamp slot.