Table 12. Exit Screen Options
Clearing NVRAM
To clear NVRAM for all devices and restart the system, perform the following steps:
1. Enter the system setup program.
2. Press the right-arrow key to move to the Advanced menu.
3. Press the down-arrow key to highlight the Boot Configuration submenu, and press <Enter>.
4. Press the down-arrow key to highlight Reset Config Data. Then change the setting to Yes (see Table 3).
5. Press <F10> to exit the program and restart the system.
Back to Contents Page
Saves any changes you have made, exits the system setup program, and restarts the system.
Discards any changes you have made, exits the system setup program, and restarts the system.
Discards any changes you have made and reverts all options to their defaults, but does not exit the system setup program.
Loads any settings saved using the Save Custom Defaults option. Press <Enter>. Then press the spacebar to select
Yes or No at the confirmation pop-up menu, and press <Enter> again.
Saves any changes you have made, but does not exit the system setup program.
Discards any changes you have made and reverts all options to their last saved settings, but does not exit the system
setup program.
