Produtos da Marca Dell

Beep Codes

If the monitor cannot display errors or problems, during POST the computer might emit a series of beeps, or beep code, that identifies the problem.

Reseating the memory modules may fix the POST beep code errors listed below. If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for

instructions on obtaining technical assistance.



If you hear one of the following POST beep codes, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining technical assistance.



one memory module (if the computer supports a single module), and then restart the computer.

If the computer starts normally, move the memory module to a different connector and restart

the computer. Continue until you have identified a faulty connector or reinstalled all modules

without error.

l If the problem still persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on

obtaining technical assistance.

If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining

technical assistance.



System board failure.

See "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining technical assistance.



Memory modules are

detected, but a memory

configuration or compatibility

error exists.

l Be sure that there are no special memory module/memory connector placement requirements.

l Verify that the memory modules that you are installing are compatible with the computer.

If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining

technical assistance.



USB port or a device

connected to it has failed

initialization.

Disconnect the device from the USB connector.

If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining

technical assistance.



Other failure.

l Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to

the system board.

l If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on

obtaining technical assistance.

If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining

technical assistance.



Computer has started and

turned over control to the

operating system.

No action is necessary.



Code

Cause

1-3-1 through 2-4-4

DIMMs not being properly identified or used

4-3-1

Memory failure above address 0FFFFh

Code

Cause

1-1-2

Microprocessor register failure

1-1-3

NVRAM

1-1-4

ROM BIOS checksum failure

1-2-1

Programmable interval timer

1-2-2

DMA initialization failure

1-2-3

DMA page register read/write failure

3-1-1

Slave DMA register failure

3-1-2

Master DMA register failure

3-1-3

Master interrupt mask register failure

3-1-4

Slave interrupt mask register failure