Dil ID: 12
Dil Adı: portugal
Dil Kodu: pt6tayfun Produtos da Marca Dell
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi
Anasayfa > Marcas > Dell > Computador > Dimension 2400
Back to Contents Page
Microprocessor
Dell™Dimension™2400Series
Removing the Microprocessor
Installing the Microprocessor
Removing the Microprocessor
1. Shut down the computer through the Start menu.
2. Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
3. Disconnect any telephone or telecommunication lines from the computer.
4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.
5. Remove the computer cover.
6. Disconnect the cooling fan power cable from the fan connector (J30) on the system board.
7. Disconnect the power cable from the microprocessor power connector (J21) on the system board.
8. Lift the air shroud to disengage the anchors and then rotate the shroud up.
9. Remove the microprocessor heat sink:
a. Twist the heat sink from side to side to break the seal.
b. Remove the retention module clip by pressing in on the tab and lifting the retention module clip up.
c. Pull the release tab out until the heat sink is released.
d. Lift the heat sink away from the microprocessor.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information
Guide.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before you open the cover.
NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the
computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.
CAUTION: The heat sink can get very hot during normal operation. Be sure that the heat sink has had sufficient time to cool before you touch it.