Dil ID: 12
Dil Adı: portugal
Dil Kodu: pt10tayfun Produtos da Marca DCS
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



IN GROUP/OUT OF GROUP
If your keyset is assigned to a station ring group, you can remove your keyset from
the group and then put it back in.While you are out of the group, you can receive
calls to your extension number but not calls to the group number. If you have an
IN/OUT key with the group number assigned.
Press the IN/OUT key. It will light red when your keyset is in the group.
Press the IN/OUT key again to exit the group and turn the light off. Repeat as
necessary.
If you do not have an IN/OUT key:
Dial the IN/OUT access code number __________, then the group number,
then 0 to exit the group or 1 to enter the group.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the handset
or press SPK or the MONITOR key.
The IN/OUT key can include an extender to indicate the specific group that this
key will affect. This means that if you are in multiple groups, you can decide for
which groups you will receive calls.
39
500_DCS_Screen.qxp 12/2/2005 9:43 AM Page 45
40
CUSTOMIZING YOUR KEYSET
AME PASSWORD
This feature allows people using the AME feature to enable password protection.
This will prevent unauthorized people from listening to your messages being left.
The passcode is the same as your station passcode. This feature only applies if
there is an SVM card installed in the system and your keyset has a programmed
AME key.
With the handset on-hook, press TRSF and then dial 110.
Dial 101 to turn on AME PASSWORD or 100 to turn it off.
Press TRSF to store your selection.
AUTO CAMP-ON
This option allows intercom calls to be automatically camped on, if possible, when
a busy station is called.
With the handset on-hook, press TRSF and then dial 110.
Press 081 to turn CAMP-ON on or 080 to turn it off.
Press TRSF to store your selection.
SELECT RING TONE
Each keyset user can select any one of eight ring frequencies:
While on-hook, press TRSF and then dial 111.
Dial 18 or press the UP and DOWN keys to hear each tone.
When you hear the tone that you prefer, press TRSF to save it.
NOTE: Specific lines or stations may be programmed to ring with a different tone
than what you have selected for you keyset.
CHANGE YOUR PASSCODE
From the factory, your station passcode is 1234.You can change your station pass-
code whenever you desire.
While on-hook, press TRSF and then dial 101.
Dial your old passcode.
Dial a new passcode (must be four characters).You can use 09.
Redial the new passcode to verify. If successful, you will hear two beeps. Four
beeps indicate an incorrect code. Reenter the code again.
Press TRSF to store the new passcode.
500_DCS_Screen.qxp 12/2/2005 9:43 AM Page 46