INSTALL/REMOVAL INSTRUCTIONS: WINDOW LIFT MOTOR
742-155
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician
before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
11
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
STEP 5: Temporarily install the power window switch. With the switch installed, raise the
window regulator to meet up with the door glass. NOTE: It may be necessary to manually
lower the door glass to align the mounting holes with the power window regulator.
STEP 6: Attach the window glass to the power window regulator.
STEP 7: Disconnect the power window switch.
STEP 8: Attach the door wiring on the door.
STEP 9: Attach the Water Vapor Barrier.
NOTE: BE SURE TO PULL THE DOOR HANDLE
CABLE ASSEMBLY AND SWITCH WIRING
THROUGH THE PRE-CUT HOLES IN THE
WATER VAPOR BARRIER.
