weatherproof adapter kit shall provide a recessed mounting for the Air Eject. A self closing,
yellow, weatherproof cover shall be used to provide a water-tight seal for the Air Eject.
The Auto Air Eject assembly shall be mounted on the exterior of the cab behind the driver's door.
MERITOR/ROCKWELL/WABCO ABS BRAKE SYSTEM
A four channel, single rear axle model, MERITOR/ROCKWELL/WABCO ABS Braking System
shall be supplied.
This ABS system shall be a 4S/4M system with four (4) wheel speed sensors and four (4)
modulator valves.
If a fault occurs in one wheel, that wheel shall have normal (non-ABS) brake function. The other
wheels shall continue to provide the ABS function. If the ABS system should fail completely, the
brake control shall be returned to normal (non-ABS) braking. An ABS warning light shall be
installed on the driver's dash message center. The light shall illuminate to warn of an ABS system
failure and shall illuminate when the diagnostic function is activated.
DEEP MUD/SNOW SWITCH
The ABS system shall be supplied with deep mud and snow switch.
MERITOR/WABCO STABILITY ENHANCEMENT SYSTEM
A Meritor / Wabco Roll Stability Control (RSC) System shall be provided on the apparatus chassis.
The RSC shall assist in managing road conditions that may result in a vehicle rollover.
The RSC shall intervene to regulate the vehicle's deceleration functions. By automatically reducing
engine torque, engage the vehicle retarder and apply pressure to the brakes.
This system shall conform to the requirements of NFPA-1901
REAR TIRES
The rear tires shall be 12R22.5-16PR (H) GOODYEAR UNISTEEL G622 RSD traction tread,
tubeless radial tires.
ALUMINUM WHEELS
Four polished aluminum wheels shall be supplied and installed on the rear axle. The wheels shall
be highly polished on the outboard side.
WHEEL TREATMENT
The aluminum wheels shall be supplied with wheel treatment for a bright finish and wheel
protection.
REAR WHEEL TRIM
The rear axle shall be trimmed with mirror finish, 304L grade non-corrosive stainless steel
"Lincoln Hat" hub cover and bright finished nut covers.
LASER ALIGNMENT
The chassis shall have a laser alignment performed at the factory before delivery.
