28
>RETRY<: start a new search.
SAVE: >Y< save your setting.
SAVE >N< reject your setting.
Diagram 10: Automatic search for
clean frequencies for a
multichannel system.
4.1 SR 450 Receiver
4.1.1 Selecting Modes
4.1.2 Selecting Screens
4. Use and to select the name of
the desired Preset.
5. Use and to select the desired
Frequency Group.
6. The receiver will automatically find
the next clean frequency.
As soon as the receiver has found a
clean frequency, the Subchannel
number assigned to this frequency
will be displayed.
Clean frequencies are frequencies
where the receiver finds no RF signal
or an RF signal whose level is lower
than the current threshold setting.
7. Refer to section 3.9.1: Program the
transmitter you assigned to channel 1
and leave power to the transmitter
ON.
8. Repeat steps 1 through 7 above for
all other channels of your system.
Be
sure to set each channel to the
same preset (country) as channel 1!
To toggle between LOCK and SETUP modes, press and hold the key for about 1.5 seconds.
When the receiver is in LOCK mode, the "LOCK" label is shown on the display. In SETUP mode, the
"LOCK" label is not shown.
Use and to select the desired status or setup screens. To call up the MHz screen, press and hold
and simultaneously for three seconds.
Diagramm 11: Selecting screens.
AUTO
CHANNEL
>EXIT<>INFO<>SQL<
>STATUS<
>NAME<
MHz
3 sec.
TX
Gain
EXTRA
PRG
IR
REHEAR
LOCK Mode:
SETUP Mode:
Preset
"AT 3.0 02"
Frequency
"750.000 MHz"
(Name)
(NAME)
PresetMHz
LOCK
LOCK
AUTO
GROUP
AUTO
CHANNEL
AUTO CHANNEL
SAVE >N<
>FREQ<
SAVE >Y<
>FREQ<
>PRG IR<
IR
3.9.1
>EXIT<
>EXIT<
>RETRY<
">AT3.001<"
FREQ
>GROUP<
"
>3.0<"
>CHANNEL<
>SCAN<
>NAME<
"
>AT<"
AKG WMS 450 V 1.10
3 Setting Up
4 Operating Notes
