Dil ID: 1
Dil Adı: english
Dil Kodu: en5tayfun Panasonic Brand's Products
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



77777
7
Troubleshooting
When you cannot connect in the Wireless
mode

signal.
How to check the strength of the wireless signal (press the Check switch)

Link LED is lighting or blinking.
<Wireless signal>




When there is no problem with the wireless signal but the Status
LED does not light

* If the wireless signal strength is BAD or worse, connect using the
Ethernet mode.
When you cannot connect in the Ethernet mode
When the Status LED does not light

Check the router connections.
Advanced Setting
When you want to set the IP of the wired LAN manually
1) Start the IP setting tool on the attached CD‑ROM and save the settings
to a USB memory device.
2) Attach the USB memory device with the saved settings to the adaptor
and press and hold the WPS switch for 10 seconds.
3) The Link LED lights when the settings are complete.
When you want to set the SSID of the wireless LAN manually
1) Start the SSID setting tool on the attached CD‑ROM and save the
settings to a USB memory device.
2) Detach the USB memory device and then attach to the adaptor and
press and hold the WPS switch for 10 seconds.
3) The Link LED lights when the settings are complete.
Link LED
Check switch

Register/Reset switch
Check switchWPS switch
Aim  Remarks
To switch WPS ON Press the WPS
switch.
This is only effective when
Wireless mode is on.
To register a user Press the Register/
Reset switch.
This is only effective when
communications have been
established.
To check the status of
communications
Press the Check
switch.
LEDs are displayed according
to the connection status.
To switch between the
Ethernet and Wireless
modes
Press the Check
switch for at least
10 seconds.
The settings for each mode
are maintained even if you
change the mode.
To reset the software Press the Register/
Reset switch for at
least 10 seconds.
This starts the process for
the software to reset itself.
When resetting, checks are

and this is updated if a new
version is available.
To specify the SSID
manually.
(in Wireless mode)
To specify the IP
manually.
(in Ethernet mode)
Press the WPS
switch for at least
10 seconds.
Connection is by WPS/
DHCP if there are no
settings to load from the
USB memory device.
To initialize the adaptor
Simultaneously
press the WPS
switch and the
Check switch for at
least 10 seconds.
This restores the adaptor’s
settings to the factory defaults.