INSTALLATION INSTRUCTIONS
STEEL
WASHER
KNOB
STAND
BRACKET
RUBBER
WASHER
3’ min. clearance
from front of heater
12” min. clearance
from sides of heater
6” min. clearance
from back and
top of heater
Distancia mínima
de 3 pies delante
del calentador
Distancia mínima
de 12” desde los
costados del calentador
6” desde la parte
posterior y superior
del calentador
1. WARNING: Risk of re. Do not use as a
residential or household heater.
2. Do not use outdoors.
3. This heater is not intended for use in bathrooms,
laundry areas, and similar indoor locations.
4. CAUTION: Do not operate without stand
attached.
5. Heater must be kept clear of all obstructions:
3 foot minimum clearance from front, 6 inch
minimum clearance from back and top, and 12
inch minimum clearance from sides. See Figure
3.
6. Always plug the heater directly into a 240 volt
wall receptacle. Never use an extension cord.
The Hot One may sit on a oor surface or be mounted to the wall using the universal stand provided. If mounted on the
wall, maintain 6 inch minimum clearance from the top of the unit to the ceiling. The Hot One is not recommended for
ceiling mount. Recommended for elevations under 7500 feet.
This heater is for use with 240 volts. The cord has a 20 amp or 30 amp plug as shown in Figure 1. No adapter is available for these
blade congurations, and none should be used. The Hot One requires a 240 volt grounded receptacle. When properly installed, it
provides a ground connection through the cord to the heater to protect the operator from electric shock. Do not use an extension cord,
power strip or any kind of adapter.
Heater Inspection
STEP 1
Thoroughly inspect your heater for any shipping or handling damage and remove any paper or packaging material around the heater.
STEP 2
Figure 4
Figure 1
Figure 2
Floor Standing
1. Loosen knobs on each side of the heater.
2. Rotate stand to desired position at bottom of heater (See Figure 2).
3. Tighten knobs.
4. Proceed to OPERATING INSTRUCTIONS.
Note: The heater must be operated with the stand attached to the heater
Wall Mount
1. Remove stand from heater by removing knobs and washers from both
sides.
2. Mount stand in desired position on wall (See Figure 3). The wall and
mounting hardware must be of adequate strength to support the heater.
Note: A 240 volt receptacle must be within six feet of the heater.
3. Install heater on stand and reassemble knobs, washers, stand and bracket
according to Figure 4.
4. Tighten knobs.
5. Proceed to OPERATING INSTRUCTIONS.
Grounding Plug and Receptacle Requirements
STEP 3
Mounting
Figure 3
Plug Conguration
Receptacle Conguration
RCP402S - 20 AmpRCP502S - 30 Amp
Receptacle Conguration
Plug Conguration
NEMA #6-30R
NEMA #6-20R
Page 3
