iTBR001-275
2008-10 Polaris RZRS - 3
Figure AFigure BFigure C
unplug
connector
unplug
connector
unplug
The ignition must be turned OFF before installation.
1 Remove both seats.
2 Remove the plastic panel behind the seats.
3 Locate the injector harness connectors as shown in Figure A.
The injector harness connectors are located next to the ignition coils.
4 Unplug the injector harness connectors.
5 Attach the Juice Box Pro connectors to the injector harness and stock wiring harness
as shown in Figure B.
6 Locate the grey 3-pin throttle position sensor (TPS) connector as shown in Figure C.
The TPS connector is located to the rear of the throttle body.
7 Unplug the TPS connector.
Note:Figure C was taken with the bed removed. This connector can be accessed
without removing the bed.
