INSTALLING YOUR REFRIGERATED DRAWERS
Select Locaon
The proper locaon will ensure peak performance of your ap-
pliance. We recommend a locaon where the unit will be out
of direct sunlight and away from heat sources. To assure your
product performs to specicaons the recommended installaon
locaon temperature range is from 55 to 100°F (13 to 38°C).
Cabinet Clearance
Venlaon is required from the boom front secon of the unit.
Keep this area open and clear of any obstrucons. Adjacent
cabinets and counter top can be installed around the unit as long
as the grille and drawer access remain unobstructed.
3
Figure 2
Do not splash or spray water from a hose on the refrigera-•
tor! Doing so may cause an electrical shock, which may
result in severe injury or death.
This unit should not, under any circumstances, be un-•
grounded.
Grounding Method
This product is factory equipped with a power supply cord that
has a three-pronged, grounded plug. It must be plugged into a
mang grounding type receptacle in accordance with the Na-
onal Electrical Code and applicable local codes and ordinances
(see Figure 2). If the circuit does not have a grounding type re-
ceptacle, it is the responsibility and obligaon of the customer to
exchange the exisng receptacle in accordance with the Naonal
Electrical Code and applicable local codes and ordinances. The
third ground prong should not, under any circumstances, be cut
or removed.
Electrical Connecon
115 volts, 3.3 amps running max. A 15 amp dedicated circuit is
required. A 3 prong grounded receptacle is required.
Leveling Legs
Front Grille, keep
this
area open.
Figure 1
Do not use an extension cord with
this appliance.
Front Grille
Do not obstruct the front grille. The openings within the front
grille provide air to ow into and exit from the refrigerator
condenser. For this reason it is important this area to not be ob-
structed and be kept clean. AGA MARVEL does not recommend
the use of custom made grilles as air ow may be restricted
because of inadequate openings. (See Figure 1).
Leveling Legs
Adjustable legs at the front and rear corners of the unit should
be set so the unit is rmly posioned on the oor and level from
side to side and front to back. Turn leveling legs clockwise to
raise unit, counterclockwise to lower it. (See Figure 1).
