2
Programming Preparation
11
Home and Office Security Safes
Notes
Step 1. Installing Batteries
The digital keypad is powered by 4 “AA” batteries which
must be installed before you can begin programming
your personal code. For your convenience, we have
provided you with 4 “AA” batteries. For best results
and depending on use, we recommend replacing the
batteries at least once a year.
1. Locate battery compartment to the right of the
digital keypad.
2. To open the compartment, press firmly in on the
battery cover and slide it to the right for removal.
3. Install 4 new “AA” batteries in the battery
compartment. Make sure they are installed in the
correct direction as marked on the inside of the
battery compartment.
4. Once the batteries are installed properly, replace
the cover by sliding it back on from the left.
Important: Battery Removal
If the batteries are removed or fail, the keypad memory will NOT be erased.
BATTERY
COMPARTMENT
Important: Override Entry to Safe
In the event that you forget your Passcode, you can obtain a Master Override
Code to gain entry into your safe. Contact our Consumer Affairs Department
at 1-800-323-9005 to get instructions on how to obtain this code. It takes
some time to complete your request, therefore, it is recommended that this
be done immediately so in the event that you forget your Passcode you
will be prepared to immediately gain access to your safe using your Master
Override Code. (See page 4 for instructions on how to open your safe using
the Master Override Code).
