Prestige 643 ADSL Router
IP Policy Routing 13-5
FIELD DESCRIPTION
Len Comp
Press [SPACE BAR
] to choose from Equal, Not Equal, Less, Greater, Less
or Equal or Greater or Equal.
Precedence
Precedence value of the incoming packet. Choices are 1, 2, 3, 4, 5, 6, 7 or
Don’t Care.
Source:
Addr start= / end= Source IP address range from start to end.
Port start= / end= Source port number range from start to end; applicable only for TCP/UDP.
Destination:
Addr start= / end= Destination IP address range from start to end.
Port start= / end= Destination port number range from start to end; applicable only for TCP/UDP.
Action=
Choose whether action should be taken on criteria Matched or Not Matched.
Gateway addr Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it’s on the LAN, otherwise, the gateway must be the IP
address of a remote node. The default gateway is specified as 0.0.0.0.
Log
Choose Yes to make an entry in the system log when a policy is executed.
Type of Service
Set the new TOS value of the outgoing packet. Choices are No Change,
Normal, Min Delay, Max Thruput or Max Reliable.
Precedence
Set the new precedence value of the outgoing packet. Choices are 1, 2, 3, 4, 5,
6, 7 or Don’t Care.
13.2 Applying an IP Policy
This section shows you where to apply the IP Policies after you design them.
13.2.1 Ethernet IP Policies
From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -General Ethernet Setup.
You can choose up to four IP Policy sets (from twelve) by entering their numbers separated by commas,
e.g., 2, 4, 7, 9.
