3-19
Step 4 : Place the adjustment plate onto the strip and slide it against the pressure rollers.
Step 5 : Pull the strip so there is an equal tension.
Caution
• Don’t pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
• Make sure that you have an equal tension on the left and right of the strip.
Step 6 : Draw a line for the second time. The following two situations can be obtained.
Line overlap each other
► well adjusted
Line does NOT overlap each other
► perform the adjustment procedure as described in the next chapter
