GB 10
Description of red indications
Red indication
lights up
Description
Causes
Solutions
“Water tap closed”
Appliance has no or insufficient water supply. The
“Start (Pause)”
light blinks.
Check whether:
•
Water tap is fully open and water supply pressure is sufficient.
•
Kinks are present in the water inlet hose.
•
Mesh filter of water supply hose is blocked (see “Care And Maintenance”.
•
The water hose is frozen up.
•
The safety valve inspection window of your water supply hose is red (provided
your appliance has a water supply hose as shown on picture
“B”
- see previous
chapter “Care And Maintenance”); replace the hose by a new one available
through our After-Sales Service or your specialist dealer.
After problem has been removed, restart programme by pressing
“Start (Pause)”
.
If the fault occurs again, contact our After-Sales Service (see next chapter).
“Clean pump”
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
•
Kinks are present in the drain hose, or the hose is blocked for another reason.
•
Filter or pump is blocked (see chapter “Draining Residual Water/ Cleaning The
Filter”;
make sure the water has cooled before draining the appliance).
•
The drain hose is frozen up.
After problem has been removed, push the “Reset” button for at least 3 seconds;
afterwards restart the desired programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
90101790GB.fm Page 10 Tuesday, August 4, 2009 4:46 PM
Black process 45.0° 130.0 LPI
