22
TROUBLESHOOTING GUIDE
•
Alarms
E1
,
E2
,
E3
,
E4
,
E9
automatically “halt” the wash programme in progress, moving it to end of cycle.
•
Alarms
E5
,
E6
interrupt the wash programme in progress and, once the fault has been remedied, allow the
programme to continue.
•
Alarm
E7
is displayed at the end of the wash programme, which is nonetheless allowed to finish since the
appliance is not prevented from working properly.
To “reset” an alarm, you must:
•
open or close the door or switch the dishwasher off and then back on again. After this course of action the
dishwasher may be programmed again.
FAULT DESCRIPTION
E1
The anti-flood system has been tripped (where present).
E2 - E9
The system that controls the water level in the dishwasher has been tripped.
E3
The dishwasher is unable to heat the water.
E4
Temperature probe disconnected.
E5
The dishwasher is unable to load water.
E6
The dishwasher is unable to drain water from the tank.
E7
The dishwasher is unable to measure the amount of water loaded precisely.
Should the fault persist, contact an authorized Service Centre.
39694621GB.fm Page 22 Monday, December 6, 2004 6:28 PM
Black process 45.0° 150.0 LPI
