TD-8810 External ADSL2+ Router User Guide
4
Chapter 2. Hardware Installation
The TD-8810 maintains three separate interfaces, one Ethernet, one ADSL and one power
adapter interface.
The Router should not be located where it will be exposed to moisture or excessive heat.
Place the Router in a location where it can be safely connected to the various devices as well as
to a power source.
2.1 System requirement
Confirm your computer has been installed with networking interface card (NIC) before connecting
ADSL Router to your computer, with operating system supporting the TCP/IP protocol.
2.1.1 LED explanation
The front panel of ADSL Router includes one power indicator (RED) and seven function indicators
(GREEN), as explained in chart below:
Name Status Indication
On Power OK
PWR
Off Power fail
Quick flash The LINE port is connecting to the ISP’s network
On The LINE port has connected to ISP’s network
ADSL
Off The LINE port has no connection
On There is mistake when ADSL transmitting or receiving data
ALARM
Off ADSL normal
On There is data transmitting or receiving on LINE port
ACT
Off No data transmitting or receiving on LINE port
On LAN port normal
Off Connection on LAN port abnormal
LAN
Flash Data transmitting or receiving on LAN port
2.2 Rear-panel
¾ ON/OFF: Turn on/off the ADSL Router’s power.
¾ Power (9V~0.8A input): Please use the provided power adaptor, otherwise may cause
damage to the ADSL Router.
¾ RESET (reset default): First press the reset button of Router, then turn on the Router’s
power for at least three seconds. It will resume the default manufacturer’s setup.
