
:: Shocks Build - Bag M-MM - Step 2
:: Shocks Build - Bag M-MM - Step 3
18
1777
FT shock
pivot ball
1777
Shock
eyelet
#1105
green slime
91480
12x23mm V2
shock bodies
(front)
91482
12x31mm V2
shock bodies
(rear)
91491
Shock hat
bushing
91491
Shock
spacer
5407
O-ring
31327
VCS3 shock
bottom cap
31327
VCS3 shock
bottom cap
o-ring
91491
12mm shock
cap o-ring
x2
x2
#1105
green slime
Racers Tip:
Lightly rub shock oil on the
o-ring before installation!
Racers Tip:
Coating the o-rings
with green slime
helps seal & reduce
o-ring swell! Green
slime is not
included in kit!
x4
91449
12mm
shock cap
Step 9-10Step 8Step 6-7Step 4-5
Front Shock: 35 wt
Rear Shock: 35 wt
Step 2-3
Shock Bleeding Steps:
1. Before assembly, get each bleed
screw and thread it 1-2 turns into the
shock cap. This will make installation
easier when you are bleeding your
shocks.
2. Pull shock shaft down.
3. Fill shock body 3/4 full with silicone
shock fluid.
4. Slowly move the shock shaft up and
down to remove air from under the
piston.
5. Wait for bubbles to come to surface.
6. Fill shock body to top with silicone
shock fluid.
7. Place a drop of oil in the cap and on
cap threads.
8. Install cap (without bleed screw) and
tighten completely.
9. Slowly compress shaft all the way to
bleed excess silicone shock fluid out
the hole in the cap (use rag around-
shock to catch excess fluid).
10. Install M2x4mm button head screw
until snug while shaft is fully com-
pressed.
Shock oil
#5429
Shock oil
#5429
31510
M2x4mm
bhcs
x4
:: Shocks Build - Bag M-MM - Step 1
91308
12mm shock
piston
(1.5 front)
(1.7 rear)
91488
3x21
shock shaft
(front)
91489
3x27.5
shock shaft
(rear)
6299
1/8 E-clip
6299
1/8 E-clip
4187
Nylon spacer,
(.030)
Racers Tip:
Use a marker over the
numbers on the pistons to
make them easily visible!
!
Front:
1 spacers
Rear:
1 spacers