SCION tC 2005 - VSE SUBWOOFER (BAZOOKA
®
)
Troubleshooting.
Condition: Check For:
1. Is the green L.E.D. lit on the VSE
Subwoofer? If not, check for 12 volts on pins
of the VSE Subwoofer with the ignition on.
If either pin doesn’t indicate 12 volts, check
T-Harness connectors behind the radio.
No sound from VSE Subwoofer, however
factory speakers still play
2. Is the 14-pin Molex connector securely
connected to the VSE Subwoofer?
3. Is the ground ring securely fastened to the
rear anchorage bolt?
Distorted Sound
1. Close the back hatch of the vehicle
2. Adjust the radio to a comfortable listening
level, and then turn the “gain control” knob
on the VSE Subwoofer counter-clockwise
until the sound becomes clean.
1. Close the back hatch of the vehicle
Low Sound
2. Adjust the radio to a comfortable listening
level, and then turn the “gain control” knob
on the VSE Subwoofer clockwise until the
sound becomes audible. Do not adjust the
level too high, as this will result in distorted
sound.
Rattling will be evident in some panels at
extreme volume conditions, but make sure
you have performed the following to
minimize noise:
Rattling Noises
1. Securely tightened Mounting Hardware so
VSE Subwoofer does not move.
Page 15 of 17 pages
Issue: A 04/15/04
