33. Use #19 throttle body gasket and
reinstall the throttle body and the throttle
cable bracket.
* Use factory bolts and nut.
35. Attach tensioner pulley as shown in
illustration. **Make sure that #14 pulley is
installed as shown, with indent facing towards
spacer.
34. The factory air cleaner hose is re-
installed.
Use factory hose clamps. Make sure all
vacuum lines are installed in the correct
position.
Throttle Body
Original throttle
Cable bracket
Genuine air cleaner
hose
14. Rib equipped pulley
⑭ Nut
20. Belt
36. Install compressor belt (#20).
* Be sure the ⑭ nut holding the tensioner pulley
is not tight.
* Be sure the tensioner pulley is all the way up.
* Please put the belt over the water pump last.
* Adjust tensioner until belt is tight, then tighten
down ⑭ nut.
⑭Collar nut
14. Pulle
15. S
acer
Indent side
12. Tensioner bolt
7. Tensioner
Bracket
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
