APPENDIX
T-650 Operations REV. 8/25/2010
110
Appendix D- Narrow Media Guide Assembly (41-105-39)
Supplement to the T-650 Operations Manual
The Narrow Media Guide Assembly is designed to help you feed media that is smaller in width
than the “standard” T-650 Media Guide Assemblies can accommodate.
With this guide in place the following revised specifications apply to the T-650:
Side Tabbing (H2 Only): Minimum media width is reduced to 3.25”.
Applying Stamps: Minimum media width is reduced to 4”.
Tabbing Perpendicular Sides: Minimum media width is reduced to 5.25”
Note: The minimum media width is still 6.5”; when applying a 1.5” tab at center of lead edge. In this
case the Narrow Media Guide Assembly is not used.
The Narrow Media Guide Assembly includes a removable Side Rail (1), which is held in place by two screws.
Install the Side Rail (1), on the Narrow Media Guide Assembly, when front tabbing media that is
between 5.25” and 6.5” wide.
Tip: When front tabbing media that is 6.5” or wider; the Narrow Media Guide Assembly is not needed and
should be removed.
Remove this Side Rail (1), from the Narrow Media Guide Assembly, when side tabbing media that is
3.25” to 5” wide; or applying stamps to media that is 4” to 5” wide.
Tip: When side tabbing or applying stamps to media that is 5” or wider; the Narrow Media Guide Assembly is
not needed and should be removed.
T-650 Reference Image:
5
6
7
14
5
Right Media Guide Assembly – The position of this
guide is adjustable. Make sure tabber transport is
moving at a medium speed before attempting to adjust
the position of this guide.
6
Center Support Plate – This plate contains the slot
used in the process of front tabbing (tabbing at leading
edge).
7
Left Media Guide Assembly - Delivers the media to
the tabbing area. Its position is not adjustable.
14
Media Thickness Adjustment Knob – This knob is
used to raise or lower the Heads and Exit Roller
Assembly when adjusting the tabber to the thickness of
the media.
