-13-
11. With the tabs feeding straight through the clamp, move the two tracking guides [Figure
11A] into contact with the backing paper edge.
Tighten the red thumbscrews.
12. Complete the tab routing through the sensor assembly, around the peel bar, through
the pressure rollers, and into the take-up roller split shaft see Figure 8 in this manual.
13. Center the sensor on the tab supply.
OPERATING HINTS
1. Fan out the envelopes before loading them into the tabber/labeler.
2. After loading the envelopes, tap the stack lightly to keep it straight between guides.
3. If doubles occur, check the stripping device for proper pressure setting.
4. Straighten out excessively curled envelopes.
Shown using Rena fan-fold tabs.
Part # 1300T, 1500T
