6. Press the start button. The programme
starts.
Using the detergent
20
30
BA D
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
the rinse aid dispenser.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode
to start a programme.
• Turn the programme knob until the sym-
bol of a programme is aligned with on/off
indicator. If the on/off indicator comes on
and the phase indicators for the pro-
gramme start to flash, the appliance is in
setting mode.
• Turn the programme knob until the sym-
bol of a programme is aligned with on/off
indicator. If the on/off and the start indi-
cators come on and a phase indicator is
on with fixed light, the appliance is not in
setting mode.
To put the appliance in setting mode, press
and hold the start button until the start indi-
cator goes off and the phase indicators for
the programme start to flash.
Starting a programme without delay
start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the until
the symbol of a programme you want to
set is aligned with the on/off indicator.
• The on/off indicator comes on.
• The phase indicators of the set pro-
gramme start to flash.
4. Press the start button. The programme
starts.
• The start indicator comes on.
• Only the indicator of the phase in op-
eration stays on.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button to delay the start
of the programme of 3 hours. The delay
indicator comes on.
3. Press the start button. The countdown
starts.
• The start indicator comes on.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the
programme starts.
20 progress
