6. Before placing the child in the child restraint,

hold the child restraint near the LATCH at-

tachment and use force to push the child

restraint from side to side, and tug it forward

to make sure that it is securely held in place.

It should not move more than 1 in (25 mm). If

it does move more than 1 in (25 mm), pull

again on the anchor attachments to further

tighten the child restraint. If you are unable to

properly secure the restraint, move the re-

straint to another seating position and try

again, or try a different child restraint. Not all

child restraints fit in all types of vehicles.

7. Check to make sure the child restraint is

properly secured prior to each use. If the

child restraint is loose, repeat steps 3

through 6.

Rear-facing

Follow these steps to install a rear-facing child

restraint using LATCH System:

1. Position the child restraint on the seat. Al-

ways follow the child restraint manufactur-

er’s instructions.

2. Secure the child restraint anchor attach-

ments to the LATCH lower anchors. Check

to make sure the LATCH attachment is prop-

erly attached to the lower anchors.

Front facing – step 6

WRS0697

Rear facing web-mounted – step 2

WRS0801

1-22 Safety—Seats, seat belts and supplemental restraint system

Z REVIEW COPY—

2008 Versa (vrs)

Owners Manual—USA_English (nna)

01/02/08—debbie