Dil ID: 8
Dil Adı: italy
Dil Kodu: it4tayfun Prodotti del Marchio MTD
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Hooked in
Middle
Adjustment
Hole
FIGURE 2
Upper
Chute
B
Hand Knob.
ASSEMBLY
INSTRUCTIONS
NOTE
This unit is shipped WITHOUT GAS
OLINE or OIL. See operation section
of this manual for proper fuel and engine
oil recommendations.
Contents of Hardware Pack:
(2) Ignition Keys (One may be on snow thrower)
1. Remove the snow thrower and loose parts from
carton. Make certain all parts and literature have
been removed from the carton before carton is
discarded.
2. Loosen the hand knob on each side of the handle.
Pull handle up into operating position. See Figure
1. Retighten the hand knob.
3. Connect the control cable to the control handle by
hooking the “Z” end of the control cable into the
-------
middle hole in control handle. See figure 2.
NOTE
The three holes in the control handle
provide adjustment for the belt ten
sion. Refer to adjustment section of
this manual when adjustment is
needed.
4. The snow thrower has been shipped with the up
per chute pivoted all the way down. Assemble as
follows.
a. Remove the hand knob, cupped washer, flat
washer and carriage bolt from the upper chute.
---------
See figure 3A.
b. Pivot the upper chute up so there is no gap be
tween the upper and lower chute. See figure
3B. Secure with hardware just removed.
5. Make certain all nuts and bolts are tightened
securely.
FIGURE 3.