This machine must be installed by an
authorised technician only. In the U.K. gas
heated machines must be installed by a
Corgi registered fitter only.
,
This machine is not designed for
washing items which have been treated
with dangerous or flammable substances.
The machine must be level and secure after
installation (see installation diagram
supplied with the machine).
To avoid the risk of frost damage do not
install this machine in a room where there is
a risk of frost occuring.
Do not install the machine on carpeted
flooring as the carpet pile can hinder the
free flow of air into the ventilation gaps at the
bottom of the machine.
Transit fittings
The red-marked transit fittings "A" on the
diagram, 2 at the front and 2 at the rear of
the machine sides are each secured in
position with a hex screw. Remove these.
The red-marked transit fittings "B" on the
diagram, 2 at the front and 2 at the rear are
each fixed with 3 hex screws.
Do not remove these until the machine has
been set in its final position. The upper
screw from the front transport fittings should
be screwed back in afterwards.
To remove the transit fittings "B", detach the
front service panel and the rear panel from
the machine. Unscrew the 3 hex screws from
the bottom edge of the front service panel to
take it off. Unscrew 8 hex screws from the
rear panel to take it off.
The front plinth facing is secured to the rear
panel, and the plinth facing for the rear
panel is under the machine lid. Both panels
should be fitted after machine has been
installed. The screws are supplied in the
accessories pack.
The plinths for the front and rear panels are
secured with the rear panel, and should be
fitted when the machine has been installed.
The screws are found in the pre-drilled
holes.
Store the transit fittings in a safe place for
future use. They will need to be refitted
should the machine every need to be
moved to another location.
The machine must not be moved without
all the outer panels in place.
Notes for the installer
M.-Nr. 06 572 490 39
