Safety instructions for
installation
Fit the wall units and rangehood
before fitting the cooktop to avoid
damaging the appliance.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This equipment is not designed for
maritime use or for use in mobile
installations such as caravans, aircraft
etc. However it may be suitable for
such usage subject to a risk
assessment of the installation being
carried out by a suitably qualified
engineer.
~
This appliance must not be installed
over a dishwasher, washing machine,
tumble dryer, refrigerator, freezer or
fridge-freezer. The high temperatures
radiated by it could damage the
appliance below.
~
After installing the cooktop, ensure
that the connection cable cannot come
into contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The sealing strip under the edge of the
top part of the cooktop provides a
sufficient seal for the worktop (see
"Sealant").
All dimensions in this instruction booklet
are given in mm.
This appliance must be installed and
connected to services in
accordance with local and national
safety and building regulations.
Installation
47
