4.3 KVM’s Switch Operation
(1) Switch Ports by Hotkey Commands
You can conveniently command KVM Switch via a simple hotkey sequence. To send commands to
KVM Switch, you must press the hotkey (default is Caps Lock) twice within 2 seconds. You will
hear a beep sound confirming you are in the hotkey mode. If you do not press any key during
hotkey mode over 2 seconds the hotkey mode will be terminated and back to normal state.
The default hotkey is Caps Lock but you can change hotkey as your application convenience. If
you prefer to use other hotkey, please go to OSD menu and change the default hotkey to the other.
The table below lists all the supported hotkey commands.
Move selection up or down
The first digit is bank number starting with “1”. The first KVM Switch on the daisy
chain line is bank 1 (the Master). A standalone KVM Switch is fixed in bank 1. The
second and the third digits indicate the port number from 01 to16.
To enable/disable beep sound function.
To enable/disable the Screen Saving function and 10min auto-logout function.
This default function is OFF.
For supervisor to activate the Auto-scan function.
For supervisor to enable/disable Security function. If the Security is off, you can
access the KVM system without user name & password. This default function is
OFF.
To login to the OSD. If Security is enabled it will display the Login window waiting
for username and password. If Security is disabled it will display the Status
window.
For supervisor to reset the OSD back to factory default value (except User
Security settings).
