1. Check the Version of the SNMP Module.
The HP AdvanceStack 10Base-T Hub in which the HP AdvanceStack
Router 210 Module is to be installed must also have an HP J2603B Eth-
ernet SNMP Module installed. (The router module will be mounted on
the SNMP module.) This SNMP module must be the HP J2603B version,
not the HP J2603A version.
If an SNMP module is already installed and you are not sure which ver-
sion it is, you can determine it in either of two ways:
By removing the cover plate from the hub’s Expansion Slot and look-
ing at the module (refer to the procedure below).
By using HP Stack Manager to display the version of the module
(refer to the procedure on page 1-7).
Looking at the SNMP Module
1. Using a Torx T-10 or flat-blade screwdriver, loosen the two captured
screws holding the cover plate over the hub’s Expansion Slot, then
remove the cover plate. Note that the screws are spring-loaded and
will release outward when unscrewed far enough. Do not unscrew
them completely from the cover plate.
Loosen these two screws
Figure 1-1. Cover Plate Screws
Installation
1. Check the Version of the SNMP Module.
1-5
