DASCOM AS/400 Set-up Guide Version 2.0 Page 8 of 10
4 SCS/DCA printing using TCP/IP
Once these parameters have been configured, and the basic TCP/IP installation of the
print server (equipped with an FSL top) has been completed, direct SCS/DCA will be
possible. This will off-load the AS/400 as Host Print Transform is not used.
Requirements:
2. AS/400 version 3.1 with TCP/IP installed and configured
3. TGNet print server with 5250 emulation
4.1 Create a remote output queue
The CRTOUTQ command is used to create a Remote output queue. This will enable the
AS/400 to automatically output SCS/DCA data directly to a TGNet print server.
The value *IP must be used for CNNTYPE
The value *OS400 must be used for DESTTYPE
The value *NO must be used for TRANSFORM
The value used for INTNETADR must be the same as the IP address of your TGNet.
4.2 AS/400 Printing
This method of printing supports various printer emulations. For Laser printers, all non-
IPDS emulations are supported. Matrix printers support the traditional IBM matrix
emulations.
When printing from OFFICE/400 care must be taken when submitting data to be printed.
The printer defined in the Print Option menu panel of OFFICE/400 must have a similar
emulation to the printer defined in the OUTQ parameter.
