© DASCOM Europe GmbH Version 1.0 Page 2 of 25
Introduction
It is assumed you have the following:
• A working knowledge of your network system and related utilities.
• Access to the supervisor or administrator account as a network administrator.
Supported Environments
The built-in network interface supports the following platforms and protocols:
• Microsoft® Windows® NT 4.0, 2000, XP, Server 2003
• Linux – Red Hat®, SuSE®
• Unix® – Sun Solaris®, HP-UX®, IBM AIX®
• TCP/IP, HTTP, LPR/LPD
Network Interface and Cabling
The printer requires:
• Ethernet 10Base-TX or 100Base-TX interface.
• Category 5e or 6 Ethernet cable with RJ-45 socket connectors.
Connecting the Printer
Connect the Ethernet cable to the network interface port RJ-45 connector on the rear center of
the printer.
Network Interface Status
There are two status lights (LEDs) next to the RJ-45 connector on the rear panel.
• Right green light (Link Status) is solid: This shows the printer is connected to the network.
• Right green light is blinking: Shows network activity.
• Left yellow light (Duplex Status) is solid: Shows network interface is in full duplex mode.
Note:
Unless the link status light is green, the printer will not be able to connect to the network.
