Paper handling Quick start guide
20
` Loading paper Your printer can process both fanfold paper and single sheets. For information on
the supported paper sizes, please refer to page 34 (“Paper specifications”).
Only use dust-free or low-dust paper. Many paper qualities are suitable for this
printer. For more information, please refer to the User guide on the Online CD-
ROM.
The printer by default is adjusted in such a way, that it will automatically check
the width of the inserted paper before starting a print job. If the paper couldn’t be
detected (for example because it is positioned too far left), the message “PW sen-
sor defect” appears in the display, it is impossible to print. If a printing line over-
rides the measured paper width, the characters out of range will not be printed and
the message “Paperwidth error” appears in the display. The printer switches to of-
fline mode. You can restart the printing process by pressing the Online key.
For further information on paper width measurment, please refer to the User
Guide on the Online CD-ROM.
Fanfold paper
Make sure that the printer is set for fanfold paper printing. If
necessary, change the paper type (see “Changing the paper
type”, page 18).
Raise the front cover.
Remove the bottom cover
A.
Open the right and left tractor flaps.
A
-
.
,
.
