Parameter initialization values . ' ■ : ;
initialization values for printing and peeling positions are described below.
Unit: rnrh (inch)
Norma!
printing
Auto-
cutter
. Peeling
Tear-off
Minimum
value
Print position
(Onnnn, form offset)
55,9
(2.2)
55.9
(2.2)
55.9
(2.2)
55,9
(2.2)
12.7
(0.5)
Cut position
(fnnn)
55.9
(2.2)
*
*
70.1
(2.8)
12,7
(0.5)
If values lower than the minimum values are set, the initialization values will be
set instead. {For values with mark *, see the separate option, operation
manuals.)
6.5.6 When "fnnn" command is executed while tear-off function is OFF
Even with the tear-off function OFF, the paper will be fed to the "fnnn“-
specified position after printing if an "fnnn > Onnnn" value is set by using the
"fnnn" command.
This function will be used for such case as another device is incorporated in
the printer.
To perform operation with the FARGO, the following is different from those in
the tear-off function ON:
• The paper is fed immediately after printing, whereas, in the tear-off
function ON the paper is fed when no data is transmitted for 0.5 second
after printing.
However, if the next print data is transmitted during printing, the printer will
start the next printing without feeding or feeding back.
6.5.7 Priority order
The following three functions (optional) cannot be performed simultaneously.
If commands for three functions are received simultaneously, the printer
will operate in the following priority order:
1st: Auto-cutter
2nd: Peeler
3rd: Tear-off function
6-16
