Prodotti del Marchio Chiligreen

- 88 -

GA-7VT600-P(-L) Motherboard

English

3. After array mode is selected, there are two methods to create a disk array. One method is Auto

Setup and the other one is Select Disk Drives. Auto Setup allows BIOS to select the disk drives

and create arrays automatically, but it does not duplicate the mirroring drives even if the user

selected Create and duplicate for RAID 1. It is recommended all disk drives are new ones when

wanting to create an array. Select Disk Drives lets the user select the array drives by their

requirements. When using Select Disk Drives, the channel column will be activated. Highlight the

target drives that you want to use and press <Enter> to select them. After all drives have been

selected, press <Esc> to go back to the creation steps menu.

VIA Technologies,Inc. VIA VT8237 Serial ATA BIOS Setting Utility V1.20

Create a RAID array with the hard disks

attached to VIA IDE controller

F1 : View Array/disk Status

L : Move to next item

Enter : Confirm the selection

ESC : Exit

Channel Driver Name Array Name Mode Size(GB) Status

[*]Serial_Ch0 Master ST380013AS SATA 74.53 Stripe0

[*]Serial_Ch1 Master ST9120023AS SATA 111.79 Stripe1

X Auto Setup For Performance

X Array Mode RAID 0 (Striping)

X Select Disk Drives

X Block Size 64K

X Start Create Process

4. If user selects a RAID 0 array in step 2, the block size of the array can also be selected. Use the

arrow key to highlight Block Size and press <Enter>, then select a block size from the popup menu.

The block size can be 4KB to 64KB.