UK
CHAPTER 5
SETTING UP INSTALLATION
Move the machine near to its permanent
position without the packaging base.
Cut tube - Holding straps
Unscrew the two top screws A and remove the
cover, sliding it off horizontally
Remove the cardboard protection.
Unscrews the two tie braces B on the
crosspiece(with a H. 19 spanner) and remove
the polystyrene spacers under it.
IMPORTANT:
DO NOT REMOVE THE SPACERS
ABOVE THE CROSSPIECE.
Replace the cover with the two screws A .
Please ensure when fitting the table top the
locating pins are inserted correctly in their
slots, positioned on the side of the cabinet as
shown in the relevant diagram.
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN
THE REACH OF CHILDREN AS IT IS A
POTENTIAL SOURCE OF DANGER.
9
