4
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
Remove the lower basket and then unscrew and remove the cap from the salt
container.
If
ou are fillin
the container for the first time ,fill 2/3 of its volume with water.
Place the end of the funnel(supplied) into the hole and introduce about 2kg of
salt .It is normal for a small amount of water to come out of the salt container
1
2
4
3
Unscrew the cap from the salt container.
There is a ring on the container with an arrow on it (see Figure to the side), if
necessary, rotate the ring in the anticlockwise direction from the "-" Setting
toward the "+" sign, based on the hardness of the water being used.It is
recommended that adjustments should be made in accordance with the following
schema:
1
2
1.
2.
The salt container must be refilled when the salt warnin
li
ht comes on. Thou
h the salt container is filled
enough, the indicator light may not black out before the salt fully dissolve.
If there are spills of the salt, a soak program could be run to wipe them out.
Contact your local water board for information on the hardness of your water supply.
The hardness of the water varies from
lace to
lace. If hard water is used in the dishwasher, de
osits will form on the dishes
and utensils.
The a
liances is e
ui
ed with a s
ecial softener that uses a salt s
ecificall
desi
ned to eliminate lime and minerals from the
water.
There are two ways to reduce the hardness: one way is using water softener, the other is using
detergent.
water
If your model have not water softener, you may skip this section.
