10
Pull Unicou
le and its hoses com
letel
out from stora
e com
artment located at rear of dishwasher
and attach it to the faucet adapter.
Turn water fully on before starting the dishwasher.
3
1
Turn off the water.
Release the water
ressure b
de
ressin
the
ressure release button. This relieves water
ressure and
rotects
ou, and the
room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
3
2
1
Remove the
ower cord
lu
from the wall rece
tacle.
Disconnect Unicouple from faucet adapter.
2
1
If faucet has not threads: attach the faucet ada
ter to faucet, then ti
hten ever
screw
of the adapter. To prevent leaking your should tighten the adapter.
2
Attach the Unicou
le connector to the faucet ada
ter b
de
ressin
the collar at the to
of the connector.
When Unicou
le is all the wa
u
onto the ada
ter, release the collar. It will then sna
Into
osition to
lock the Unicouple in place. The Unicouple s small hose carries water from the faucet to the dishwasher.
Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain
opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher
drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
'
Connector of ModelⅠ
A hose that attaches to a sink s
ra
can burst if it is installed on the same water line as the dishwasher. If
our sink has one, it is
recommended thet the hose be disconnected and the hole plugged.
Fused electrical su
l
is re
uired-co
er wire onl
. Time dela
fuse or circuit breaker recommended and
rovide se
arate
circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
Make sure that the plug on the appliance remains accessible after installation.
After making sure that the voltage and the frequency values for the current in the home
correspond to those on the rating plate and that the electrical system is sized for the
maximum voltage on the rating plate, insert the plug into an electrical socket which is
earthed properly. If the electrical socket to which the appliance must be connected is not
appropriate for the , replace the socket ,rather than
using a adaptors or the like as they could cause overheating and burns.
plug (installed by a qualified electrician)
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
