11
What to do if ...
ʑ
Water is running out. – Fit/refit drainage hose.
– Tighten screw–fitting on the supply hose.
ʑ
Water not flowing in.
Detergent not washed in.
The
(Ready) and (End)
indicator lights flash.
– Tap not open?
– Filter blocked? Clean filter
a Page 9.
– Water inlet hose kinked or jammed?
ʑ
Washing machine door cannot be
opened.
– Safety function active. Programme stopped?
– Water in drum? Select Spin
Å or Empty >.
ʑ
Programme does not start.
The
(Ready) and 2 (Rinse)
indicator lights flash.
– Start/Pause $ not selected.
– Washing machine door not closed properly.
ʑ
Detergent solution is not drained.
The 2 (Rinse) and
(End)
indicator lights flash.
– Clean detergent solution pump a Page 9.
– Clean outlet pipe and/or drainage hose.
ʑ
Additional function could not
activate for selected programme.
– Can the additional function be selected? a Page 7,
programme overview.
ʑ
Water not visible in the drum. – Not a fault - water below the visible area.
ʑ
Spin cycle actuated several times. – Not a fault - unbalanced load detection system adjusts
imbalance.
ʑ
Detergent in chamber I is not
washed away.
– + Prewash 760 ੬ programme not selected ?
ʑ
Detergent residue in the detergent
dispenser
– Detergent is damp or lumpy, clean the detergent
dispenser a Page 8.
– Use the dosing aid for liquid detergent.
ʑ
Foam is coming out of the
detergent drawer.
– Too much detergent used?
Mix 1 tablespoon of fabric conditioner with ½ a litre of
water and pour into dispenser II in the detergent drawer.
– Reduce detergent dosage for the next wash cycle.
ʑ
Excessive noise, vibrations and
”wandering” during spin cycle.
– Appliance feet fixed?
Secure appliance feet
a Installation instructions.
– Transportation bolt removed?
Remove transportation bolt
a Installation instructions.
ʑ
Indicator lights do not function
while the appliance is running.
– Power failure?
– Circuit breaker tripped? Reset the circuit breaker/
change the fuse.
– If the fault occurs repeatedly, contact customer service.
ʑ
Programme sequence longer than
usual
– Not a fault-unbalanced load detection system is
adjusting the imbalance by repeatedly distributing the
laundry .
– Not a fault - foam detection sysytem active.
ʑ
Detergent residues on the laundry – Occasionally, phosphate-free detergents contain water-
insoluble residues.
– Select Rinse or blush the laundry after washing.
ʑ
Washing result not satisfactory – Soiling is greater than expected? Select a suitable
programme or reduce load.
– Detergent is underdosed?
ʑ
If you cannot correct a fault yourself or a repair is required:
– Set the programme selector to
Off and pull the mains plug out of the socket.
– Turn off the tap and call the customer services.
