EN-74
Manually Configuring Network Settings
EN-74
Manually Configuring Network Settings
section
2
1
3
4
5
6
7
8
9
10
Manually Configuring Network Settings
4. Select the “TCP/IP” tab (3). Next to “Configure” (4), you should
see “Manually” or “Using DHCP”. If you do not, check the
PPPoE tab (5) to make sure that “Connect using PPPoE” is
NOT selected. If it is, you will need to configure your Modem
Router for a PPPoE connection type using your user name and
password.
5. If “Manually” is selected, your Modem Router will need to be set
up for a static IP connection type. Write the address information
in the table below. You will need to enter this information into
the Modem Router.
6. If not already selected, select “Using DHCP” next to “Configure”
(4), then click “Apply Now”.
Your network settings are now configured for use with the
Modem Router.
EN-74
