indicator of the running phase
flashes.
• The drum still turns at regular intervals
to prevent the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Essorage
button to decrease the spin speed
proposed by the appliance.
2. Touch the Départ/Pause button:
• If you have set
, the appliance
drains the water and spins.
• If you have set , the appliance
only drains the water.
The option indicator
or goes out,
while the indicator flashes and then
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the Marche/Arrêt button a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
10.16 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Départ/
Pause button.
Press the button Marche/Arrêt to
activate the appliance again.
• After 5 minutes from the end of the
washing programme
Press the Marche/Arrêt button to
activate the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
11.1 NON-STOP programme -
Wash and dry
Not all programmes are
compatible with drying
function. The Propre&Sec
ÖKOPower programme is
already a complete
wash&dry programme.
You can wash and dry your laundry
setting a «non stop-programme».
Proceed as follows:
1. Press the Marche/Arrêt button for
some seconds to activate the
appliance.
2. Turn the programme dial to the
desired washing programme. The
display shows the default
temperature and spin. If necessary,
change them according to your
laundry. The display also shows the
maximum recommended load for
washing phase.
3. Set the desired options, if there are
available.
4. Touch the Mode button once to
activate also the drying function. The
Lavage and Séchage indicators come
on. The indicators
and
appear on the display. The display
also shows the maximum
recommended load for a washing
www.aeg.com
28
