Operating Instructions
24
Start the Washing Program
0 1. Check that the water valve is open.
2. Start the washing program: Press the button START/
PAUSE (INÍCIO/PAUSA). The washing program is
started or it starts after the set time expires.
3
The filling door is not correctly closed if, when the button START/PAUSE
(INÍCIO/PAUSA) is pressed,
– the indicator DOOR (PORTA) flashes red
– the fault code E40 in the multidisplay flashes
– and the indicator MAIN WASH (LAVAGEM) flashes.
In this case, press the filling door firmly closed and again press the but-
ton START/PAUSE (INÍCIO/PAUSA).
If the time preselection is set:
A set time preselection runs and the remaining time until the program
start is displayed (in each case in full hours, e.g. 5h). During this time
you can load washing or change/abort the time preselection.
• Load washing: Press the button START/PAUSE (INÍCIO/PAUSA). The
filling door can be opened. Next, close the door and again press the
button START/PAUSE (INÍCIO/PAUSA).
• Change or abort time preselection: Press the button DELAY TIMER
(INÍCIO DIFERIDO) as often as necessary until the required time is dis-
played; when the program run time is displayed (display in minutes,
e.g.126), the washing program starts without delay.
Completion of the Washing Program
Program sequence display
Before the start, the program steps to be carried out
are indicated by the Program sequence display. The
current program step is displayed during the washing
program.
Multi-display
The expected remaining run time (in min-
utes) is displayed in the multi display until
the end of the program.
3
With automatic program adaptation by the controller of the washing
machine, (quantity of washing, type of washing, imbalance recognition,
special rinse etc.) it is possible to stop or correct the counting of the re-
maining run time.
