Instructions for use
26
Washing Cycle Ended/Remove Washing
After a washing program has ended, END (EINDE, FIN) lights up on the
program sequence display.
• A crease protection phase of approx. 30 minutes follows at the end of
the program if program EASY IRON (STRIJKVRIJ, SANS REPASSAGE)
had been selected. The multidisplay also shows the remaining time
and the display END (EINDE, FIN) is illuminated. You can open the fill-
ing door and take the washing out at any time during the crease pro-
tection phase..
• If you selected RINSE HOLD (GEEN CENTR., SANS ESSOR.), the indica-
tor next to the button START/PAUSE (START/PAUZE, MARCHE/
PAUSE) flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– either press the button START/PAUSE (START/PAUZE, MARCHE/
PAUSE) (water is pumped off and the washing is spun according to
the program which has just run; with the button Spin speed/RINSE
HOLD (GEEN CENTR., SANS ESSOR.), the spin speed can also still be
changed during spinning), or
– turn the program selector to PUMP (POMPEN, VIDANGE) and press
the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) (the water
is pumped off without spinning), or
– turn the program selector to SPIN (CENTRIFUG., ESSORAGE) or SHORT
SPIN (KORT CENTRIFUG., ESSOR. DELICAT), and press the button
START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off
and the washing is spun or gently spun).
After the end of this program step, the indicator END (EINDE, FIN)
lights up.
2. Open the filling door.
As soon as the indicator next to the button DOOR/LIGHT (DEUR/LICHT,
PORTE/ECLAIR.) lights up green, the filling door can be opened (not
when the program safeguard is activated, for details see ”Program
Safeguard”).
3. Remove the washing.
4. Turn the program selector to OFF (UIT, ARRET).
5. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
